Setting the Power Liftgate 3/4 Mode
To change the liftgate stop position.
1. Turn the liftgate switch to either the MAX, or the 3/4 mode position and
power open the liftgate.
2. Stop the liftgate movement at the desired height by pressing any liftgate
switch. Manually adjust the liftgate position if required.
3. Press and hold the button on the liftgate next to the latch until the turn
signals flash and a beep sounds to indicate that the new setting is recorded.
When power opened with the 3/4 mode selected, the liftgate stops at the new set position.
If you do not receive the audible and visual feedback when setting the intermediate stop position, you are attempting to set the height below the 3/4 open height minimum (approximately 1.52m or 5 ft).
The liftgate cannot be set below that minimum and the new setting will not be recorded.
See also:
Vehicle Data Recording and Privacy
This GM vehicle has a number of sophisticated computers that record
information about the vehicle’s performance and how it is driven.
For example, the vehicle uses computer modules to monitor and ...
Timer
This display can be used as a timer. To start the timer, press SET/CLR while
Timer is displayed.
The display will show the amount of time that has passed since the timer was
last reset. To stop t ...
Reverse Tilt Mirror
This allows you to turn the reverse tilt mirror feature on or off. When on,
both the driver and passenger mirrors will tilt downward when vehicle is
shifted to R (Reverse) to improve visibility of t ...