Video Screens
The video screens are located in the back of the driver and front passenger seats.
To use the video screen:
1. Push the release button located on the seatback console.
2. Move the screen to the desired viewing position.
Push the video screen down into its locked position when it is not in use.
The screen turns off automatically.
Only the left RSE seatback console contains the infrared transmitters for the wireless headphones.
They may be visible as eight illuminated LEDs. These LEDs are not on the right video screen.
Both seatback consoles contain an infrared receiver for the remote control. They are located at the top of each console.
Notice: Avoid directly touching the video screen, as damage may occur. See “Cleaning the Video Screens” later in this section for more information.
See also:
Wheels and Trim—Aluminum or Chrome
Use a soft, clean cloth with mild soap and water to clean the wheels. After rinsing
thoroughly with clean water, dry with a soft, clean towel. A wax may then be applied.
Keep the wheels clean using ...
SBZA Detection Zones
The SBZA sensor covers a zone of approximately one lane over from both sides
of the vehicle, 3.5m (11 ft). This zone starts at each side mirror and goes back
approximately 5.0m(16 ft). The heigh ...
Reporting Safety Defects to the United States Government
If you believe that your vehicle has a defect which could cause a crash or could
cause injury or death, you should immediately inform the National Highway Traffic
Safety Administration (NHTSA) in ...