Low-Beam Headlamps/Daytime Running Lamps (DRL), High-Beam Headlamps (Base)
1. From the back side of the headlamp assembly, remove the top cap to replace the low-beam headlamp/DRL bulb.
2. From the back side of the headlamp assembly, remove the bottom cap to
replace the high-beam headlamp bulb.
3. Disconnect electrical connector.
4. Remove the bulb socket from the headlamp assembly.
5. Replace the bulb in the bulb socket.
6. Install the bulb socket in the headlamp assembly.
7. Connect the electrical connector.
8. Install the cap with the down arrow pointing down in the back of the
headlamp assembly.
9. For driver side, reinstall the underhood electrical center cover by latching
three clips.
10. For passenger side, reinstall the air filter/cleaner assembly base by
pushing to seat.
Verify the base is seated securely, then install the engine air filter/cleaner assembly.
See also:
Starting the Engine Using Remote Start
1. Press and release on the RKE transmitter.
2. Within two seconds, press and hold until the turn signal lamps flash. This
confirms the request to remote start the vehicle has been received. If the
...
Conversions and
Add-Ons
Add-On Electrical
Equipment
Notice: Do not add anything
electrical to the vehicle unless
you check with your dealer first.
Some electrical equipment can
damage the vehicle and the
damage w ...
Audio/Video (A/V) Jacks
The A/V jacks may be located on the rear of the floor console.
They allow audio or video cables to be connected from an auxiliary device
such as a camcorder or a video game system.
The A/V jack ...