Back-Up Lamps
To replace one of these bulbs:
1. Open the liftgate. See Liftgate .
A. Push Pin
B. Taillamp Cover
2. Pull on push pin (A) to release the taillamp cover (B).
3. Remove the taillamp cover from the lamp assembly by pulling rearward from
the top to unfasten from snap tabs.
4. Remove the two screws from the taillamp assembly.
5. Pull the taillamp assembly straight back to remove.
A. Turn Signal Lamp
B. Back–Up Bulb/Socket Assembly
6. Disconnect the wire harness from the back–up bulb/socket (B).
7. Turn the back–up bulb socket counterclockwise to remove it from the taillamp
assembly.
8. Install a new bulb/socket assembly into the taillamp assembly and turn the
bulb/ socket clockwise until it clicks.
9. Reinstall the taillamp assembly and tighten the screws.
10. Reinstall the taillamp cover by snapping it into place.
11. Push the push pin to secure the taillamp cover.
See also:
Roadside Service (Mexico)
As a new owner, your vehicle is automatically enrolled in the Roadside
Assistance program.
The services are available at no cost under the terms and conditions of the
program. The Roadside Assist ...
Special Application Services
Severe Commercial Use Vehicles Only: Lubricate chassis components every
5 000 km/ 3,000 mi.
Have underbody flushing service performed once a year.
...
Listing All Paired and Connected
Phones
1. Press and hold for
two seconds. For vehicles with
a navigation system say
“Hands Free” after the tone.
2. Say “Bluetooth.”
3. Say “List.” ...