Setting the Power Liftgate Intermediate Mode
To change the liftgate stop position:
1. Turn the liftgate switch to either the MAX, or the ¾ mode position and power open the liftgate.
2. Stop the liftgate movement at the desired height by pressing any button that operates the power liftgate, or the touch pad.
Manually adjust the liftgate position if required.
3. Press and hold the button on the liftgate adjacent to the latch until the turn signals flash and a beep sounds to indicate that the new setting is recorded.
When power opened with the ¾ mode selected, the liftgate stops at the new set position.
If an audible and visual response is not received when setting the intermediate stop position, the liftgate height is below the ¾ open height minimum, approximately 1.52m(5 ft) at the edge of the liftgate.
See also:
Exit Lighting
The headlamps, taillamps, parking lamps, back—up lamps, and license plate
lamps come on at night, or in areas with limited lighting, when a door is
opened after the ignition is turned off. The dome ...
Heated and Ventilated Front Seats
WARNING
If you cannot feel temperature change or pain to the skin, the seat heater may
cause burns even at low temperatures. To reduce the risk of burns, people with such
a condition should ...
Cargo Management System (Wagon Only)
Press the bottom of the load floor
handle assembly to lift the top on
the handle. Pull up on the handle
to open the cargo management
system.
The cover can be opened to two
positions to ...