Programming the Power Windows
If the vehicle battery has been recharged, disconnected or not working, the front power windows will need to be reprogrammed for the express-up feature to work.
Before reprogramming, replace or recharge the vehicle's battery.
To program:
1. With the ignition in ON/RUN or ACC/ACCESSORY, or when Retained Accessory Power (RAP) is active, close all doors.
2. Press and hold the power window switch until the window is fully open.
3. Pull the power window switch up until the window is fully closed.
4. Continue holding the switch up for approximately two seconds after the window is completely closed.
The window is now reprogrammed.
Repeat the process for the other windows.
See also:
Voice Pass-Thru
Voice Pass-Thru allows access to
the voice recognition commands on
the cell phone. See the cell phone
manufacturer's user guide to see if
the cell phone supports this feature.
This feature ca ...
Back-Up Lamps
To replace this bulb:
1. Open the liftgate. See Liftgate for more information.
2. Remove the two screws from the taillamp assembly.
3. Pull the taillamp assembly rearward until the ...
Manual Mode
Driver Shift Control (DSC) or
Tap Shift
Notice: Driving with the engine
at a high rpm without upshifting
while using Driver Shift Control
(DSC), could damage the vehicle.
Always upshift when ...