Automatic Entry Recall
If entry/exit recall is programmed on in the vehicle personalization menu, automatic entry recall occurs when the ignition is turned on.
See Vehicle Personalization.
To stop recall movement, press one of the power seat, memory, or outside mirror buttons, or the power steering column switch, if equipped.
If something has blocked the driver seat or the steering column while recalling a memory position, the recall may stop. Remove the obstruction; then press the appropriate control for the area that is not recalling for two seconds.
Try recalling the memory position again by pressing the appropriate memory button. If the memory position is still not recalling, see your dealer for service.
See also:
Returning the Seatback to the Upright Position
To return the seatback to the upright position:
1. Open the liftgate to access the controls for the seat.
2. Raise the seatback to the upright position.
WARNING
If either seatback is not lock ...
Using Voice Commands
During a Planned Route
Cancel Route
1. Push . System responds:
“OnStar ready,” then a tone.
Say “Cancel route.” System
responds: “Would you like to
cancel route directions to your
destination?”.
2. Say “Yes.” Syst ...
Steering Wheel Adjustment
Push the control up or down to tilt the steering wheel up or down.
To set the memory position, see Vehicle Personalization . ...