SERVICE ALL WHEEL DRIVE
This message displays if a problem
occurs with the All-Wheel Drive
(AWD) system. The vehicle will run
in 2WD. This could be caused by:
- An electronics problem
- An AWD system oil overheat
- Worn out or overheated clutch plates
- Various electrical issues
If this message appears, stop as soon as possible and turn off the ignition for 30 seconds. Restart the vehicle and check for the message on the DIC display. If the message still displays or appears again when you begin driving, the system needs service. See your dealer right away.
See also:
Muting a Call
During a call, all sounds from inside the vehicle can be muted so that the
person on the other end of the call cannot hear them.
To mute a call, press , and then say “Mute Call.” To cancel
mute, ...
Average Vehicle Speed
The Average Vehicle Speed display shows the average speed of the vehicle in
kilometers per hour (km/h) or miles per hour (mph).
This average is calculated based on the various vehicle speeds recor ...
Care of Safety Belts
Keep belts clean and dry.
WARNING!
Do not bleach or dye safety belts.
It may severely weaken them.
In a crash, they might not be able
to provide adequate protection.
Clean safety belts only wit ...