Universal Remote System Operation
Using Universal Remote
Press and hold the appropriate Universal Remote button for at least half of a second. The indicator light will come on while the signal is being transmitted.
Erasing Universal Remote Buttons
All programmed buttons should be erased when the vehicle is sold or the lease ends.
To erase all programmed buttons on the Universal Remote device:
1. Press and hold down the two outside buttons until the indicator light begins to flash, after 20 seconds.
2. Release both buttons.
Reprogramming a Single Universal Remote Button
To reprogram any of the three Universal Remote buttons, repeat the programming instructions earlier in this section, beginning with Step 2.
For help or information on the Universal Home Remote System, call the customer assistance phone number under Customer Assistance Offices (U.S. and Canada) or Customer Assistance Offices (Mexico).
See also:
Removing the Spare Tire and
Tools (Sedan)
Sedan
A. Wing Nut
B. Spare Tire
C. Jack
D. Wheel Wrench
E. Extension (If Equipped)
F. Strap
To access the spare tire and jacking
equipment:
1. Remove the spare tire cover.
2. Remove the f ...
Before Driving
The RSE is for rear seat passengers only. The driver cannot safely view the
video screen while driving.
In severe or extreme weather conditions the RSE system may not work until
the temperature i ...
Point of Interest (POI)
The Point of Interest (POI) destination entry method lets you select a destination
from the POI list.
Point of Interest: Press to access
the POI (Point of Interest) screen. From this screen yo ...