Adjusting the Speakers (Balance/Fade)
BAL/FADE (Balance/Fade):
To adjust balance or fade:
1. Press the TUNE/TONE knob until the speaker control tabs display.
2. Continue pressing the TUNE/ TONE knob, or press the softkey under the desired tab to highlight the desired tone setting.
3. To increase the highlighted setting, do one of the following:
- Turn the TUNE/TONE knob clockwise.
- Turn the MENU/SELECT knob clockwise.
- Press the 
button.
- Press the 
button.
4. To decrease the highlighted setting, do one of the following:
- Turn the TUNE/TONE knob counterclockwise.
- Turn the MENU/SELECT knob counterclockwise.
- Press the 
button.
- Press the 
button.
To quickly adjust balance or fade to the middle position, press the softkey under the BAL or FADE tab for more than two seconds.
To quickly adjust all speaker and tone controls to the middle position, press the TUNE/TONE knob for more than two seconds.
See also:
Pulling a Trailer
Here are some important points:
There are many different laws, including speed limit restrictions, having
to do with trailering. Make sure the rig will be legal, not only where you live
but ...
Fuel System Messages
FUEL LEVEL LOW
This message displays when the vehicle is low on fuel. Refuel as soon as
possible
TIGHTEN GAS CAP
This message displays when the fuel cap is not on tight. Tighten the fuel
ca ...
SBZA Detection Zones
The SBZA sensor covers a zone
of approximately one lane over
from both sides of the vehicle,
or 3.5m(11 ft). This zone starts at
each side mirror and goes back
approximately 5.0 m(16 ft).
T ...