Voice Pass-Thru

Voice Pass-Thru allows access to the voice recognition commands on the cell phone. See the cell phone manufacturer's user guide to see if the cell phone supports this feature.

This feature can be used to verbally access contacts stored in the cell phone.

1. Press and hold two seconds. For vehicles with a for two seconds. For vehicles with a navigation system say “Hands Free” after the tone.

2. Say “Bluetooth.” This command can be skipped.

3. Say “Voice.” The system responds with “OK, accessing <phone name>.” . The cell phone's normal prompt messages will go through their cycle according to the phone's operating instructions.

    See also:

    Rear Compartment Fuse Block (CTS-V Coupe and Sedan)
    The rear compartment fuse block is located on top of the battery, on the right side of the trunk. The battery access door must be removed to access the fuse block. The vehicle may not be equi ...

    Tire and Loading Information Label
    Label Example A vehicle-specific Tire and Loading Information label is attached to the vehicle's center pillar (B-pillar). With the driver door open, you will find the label attached near ...

    When the System Does Not Seem to Work Properly
    The following messages may be displayed on the DIC: PARKING ASSIST OFF: This message occurs if the driver disables the system or if vehicle is driven above 8 km/h (5 mph) in R (Reverse). S ...