Checking Coolant
The vehicle must be on a level surface when checking the coolant level.
The engine coolant reservoir is located in the engine compartment on the driver side of the vehicle.
See Engine Compartment Overview.
Check to see if coolant is visible in the surge tank. If the coolant inside the surge tank is boiling, do not do anything else until it cools down.
If coolant is visible but the coolant level is not at or above the FULL COLD mark, add a 50/50 mixture of clean, drinkable water and DEX-COOL coolant at the coolant surge tank, but be sure the cooling system is cool before this is done.
If the engine is warm or hot, the coolant level should be at or above the FROID/FULL COLD line on the side of the coolant surge tank. If the engine is cold, the coolant level should be near the FROID/FULL COLD line on the side of the coolant surge tank. If it is not, there could be a leak in the cooling system.
See also:
Adding Destinations to the Address Book
There are two ways to add a destination to the address book:
To add the current vehicle position to the address book, press the Mark
screen button from the map screen. The system automatically ...
Emissions Inspection and Maintenance Programs
Some local governments may have programs to inspect the on-vehicle emission control
equipment. For the inspection, the emission system test equipment is connected to
the vehicle’s Data Link Connec ...
Temperature – A, B, C
The temperature grades are A (the highest), B, and C, representing the tire's
resistance to the generation of heat and its ability to dissipate heat when tested
under controlled conditions on ...