Programming the Power Windows
Programming the power windows may be necessary if the vehicle's battery has been disconnected or discharged.
If the window will not express up after power has been restored and a message is displayed in the Driver Information Center:
1. Close all doors.
2. Place the ignition in ACC/ACCESSORY or ON/RUN/START.
3. From any partial open position, close the window and continue to pull the
switch briefly after the window has fully closed.
See also:
Increasing Speed While Using Cruise Control
If the cruise control system is already activated,
. Press and hold the +RES button on the steering wheel until the desired speed
is reached, then release it.
. To increase vehicle speed in small ...
Front Turn Signal Lamp (Base and Uplevel)
To replace the Front Turn Signal Lamp:
1. Remove the turn signal lamp bulb socket from the headlamp assembly.
2. Remove the turn signal lamp bulb from the socket.
3. Replace the bulb in the bulb ...
Using Your Stored Preset Destinations
These destinations are available for selection while driving.
1. Press to turn the system on.
2. A caution may appear. Press OK to proceed.
3. Press DEST.
4. Select one of the available preset de ...






