Rainsense™

For vehicles with Rainsense, a sensor located near the top center of the windshield detects the amount of water on the windshield and automatically controls the frequency of the windshield wiper.

Keep this area of the windshield clear of debris to allow for best system performance.

border=0>

INT (Rainsense Wipe Sensitivity Control): Move the windshield wiper lever to INT. Turn the src=INT band on the wiper lever to adjust the" width=28 height=19 id="_x0000_i1308" src="images/books/1183/3/index.48.gif" border=0>INT band on the wiper lever to adjust the sensitivity.

- Turn the band up for more sensitivity to moisture.
- Turn the band down for less sensitivity to moisture.
- Move the windshield wiper lever out of the INT position to deactivate Rainsense.

    See also:

    SBZA Detection Zones
    The SBZA sensor covers a zone of approximately one lane over from both sides of the vehicle, or 3.5m(11 ft). This zone starts at each side mirror and goes back approximately 5.0 m(16 ft). T ...

    Flash-to-Pass
    Use your high-beam headlamps to signal to a driver in front that you want to pass. It works even if the headlamps are in the automatic position. To use it, pull the turn signal lever toward you, th ...

    Security
    OnStar provides services like Stolen Vehicle Assistance, Remote Ignition Block, and Roadside Assistance, if the vehicle is equipped with these services. OnStar can unlock the vehicle doors remotel ...