Timer
This display can be used as a timer. To start the timer, press SET/CLR while Timer is displayed.
The display will show the amount of time that has passed since the timer was last reset. To stop the timer, press SET/CLR briefly while Elapsed Time is displayed. To reset the timer to zero, press and hold SET/CLR.
See also:
Rear Vision Camera Location
The camera is located above the license plate.
The area displayed by the camera is limited.
It does not display objects that are close to either corner or under the
bumper and can vary depe ...
Using the Tire Sealant and Compressor Kit without Sealant to Inflate a Tire
(Not Punctured)
To use the air compressor to inflate a tire with air only and not sealant:
If a tire goes flat, avoid further tire and wheel damage by driving slowly to
a level place. Turn on the hazard warning ...
Rainsense™
For vehicles with Rainsense, a
sensor located near the top center
of the windshield detects the
amount of water on the windshield
and automatically controls the
frequency of the windshield w ...