Flash-to-Pass
The flash—to—pass feature works with the low beams or Daytime Running Lamps (DRL) on or off.
To flash the high beams, pull the turn signal/lane change lever all the way toward you, then release it.
See also:
Objects Detected by Both the Front and Rear Sensors
In general, if objects are detected at the same time near both the front and
rear bumpers while backing up, the beeps only sound to indicate that objects
are close to the rear bumper.
However, if ...
Conditions in Which Remote Start Will Not Work
The remote start will not operate if any of the following occur:
- The ignition is in any mode other than OFF.
- The transmitter is in the vehicle.
- The hood is not closed.
- The hazard warning ...
Bluetooth®
The Bluetooth system allows users
with a Bluetooth-enabled cell phone
to make and receive hands-free
calls using the vehicle audio system
and controls.
The Bluetooth-enabled cell phone
must ...