Listing Stored Numbers

The list command will list all the stored numbers and name tags.

Using the “List” Command.

1. Press src=. The system responds “Ready,” followed by" width=43 height=18 id="_x0000_i1556" src="images/books/1183/4/index.65.gif" border=0>. The system responds “Ready,” followed by a tone.
2. Say “Directory.”
3. Say “Hands Free Calling.”
4. Say “List.”

    See also:

    Turn Signal Lamps
    To replace one of these bulbs: 1. Open the liftgate. See Liftgate . A. Push Pin B. Taillamp Cover 2. Pull on push pin (A) to release the taillamp cover (B). 3. Remove the taillamp cover ...

    Battery Replacement
    To change the remote control batteries: 1. Slide the rear cover back on the remote control. 2. Replace the two batteries in the compartment. Make sure they are installed correctly using the diagra ...

    Temperature – A, B, C
    The temperature grades are A (the highest), B, and C, representing the tire's resistance to the generation of heat and its ability to dissipate heat when tested under controlled conditions on ...