Automatic Operation
The system automatically controls the fan speed, air delivery, air conditioning and recirculation in order to heat or cool the vehicle to the desired temperature.
When the indicator light is on, the system is in full automatic operation. If the air delivery mode or fan setting is manually adjusted, the auto indicator turns off and displays will show the selected settings.
To place the system in automatic mode do the following:
1. Press AUTO.
2. Set the temperature. Allow the system time to stabilize.
Then adjust the temperature as needed for best comfort.
English units can be changed to metric units through the Driver Information Center (DIC).
See Vehicle Personalization.
(Driver and Passenger Temperature Controls): The temperature can be
adjusted separately for the driver and the passenger. Press to increase or
decrease the temperature.
ZONE: Press to link all climate zone settings to the driver settings.
The ZONE indicator light turns off.
When the passenger settings are adjusted, the ZONE indicator light is on.
See also:
Manual Operation of Power Liftgate
To change the liftgate to manual operation, turn the mode switch to the OFF
position.
With the power liftgate disabled and all of the doors unlocked, the liftgate
can be manually opened and close ...
Treadwear
The treadwear grade is a
comparative rating based on the
wear rate of the tire when tested
under controlled conditions on
a specified government test
course. For example, a tire
graded 150 ...
Starting the Engine Using Remote Start
1. Press and release on the RKE transmitter.
2. Within two seconds, press and hold until the turn signal lamps flash. This
confirms the request to remote start the vehicle has been received. If the
...






