Setting the Clock
The analog clock is located on the instrument panel above the radio.
The clock is not connected with any other vehicle system and runs by itself. To adjust the clock:
1. Locate the adjustment buttons directly below the clock face.
2. Push and hold the right adjustment button to move the clock hands forward, or the left adjustment button to make the clock hands go backward.
Holding either button down will cause the clock to advance faster. Release the button before the desired time is reached.
3. Push and release either button to adjust the time by one minute increments until the desired time is reached.
For more information on setting the clock, see Clock.
See also:
Using the Tire Sealant
and Compressor Kit to
Temporarily Seal and Inflate a
Punctured Tire
Follow the directions closely for
correct sealant usage.
When using the tire sealant and
compressor kit during cold
temperatures, warm the kit in a
heated environment for five minutes.
Thi ...
Turning the System On and Off
The system can be disabled through
the Driver Information Center (DIC).
See “Parking Assist” under Driver
Information Center (DIC) for more information.
URPA defaults to the on setting
each ti ...
Tire Pressure Monitor Operation
This vehicle may have a Tire Pressure Monitor System (TPMS). The TPMS is designed
to warn the driver when a low tire pressure condition exists. TPMS sensors are mounted
onto each tire and wheel as ...