Compass Calibration Procedure

1. Before calibrating the compass, check that the compass is set to the correct variance zone.

See “Compass Variance (Zone) Procedure” earlier in this section.

Do not operate any switches such as window, sunroof, climate controls, seats, etc.

during the calibration procedure.

2. Press TO until PRESS CALIBRATE COMPASS TO CALIBRATE COMPASS displays.

3. Press calibration. to start the compass calibration.

4. The DIC will display CALIBRATING DRIVE IN CIRCLES. Drive the vehicle in tight circles at less than 8 km/h (5mph) to complete the calibration. The DIC will display CALIBRATION COMPLETE for a few seconds then returns to the PRESS COMPASS display. TO CALIBRATE COMPASS display.

    See also:

    Rear Window Defogger
    The rear window defogger uses a warming grid to remove fog or frost from the rear window. It only works when the ignition is in ON/RUN. (Rear Window Defogger): Press to turn the rear window ...

    Using UHP with Infotainment Controls
    Pairing a Phone If your mobile phone has simple pairing or auto discovery features, they need to be turned off before the mobile phone can be paired to the UHP system. Reference the mobile phone ...

    Brake System Messages
    BRAKE FLUID LOW This message is displayed when the brake fluid level is low. See Brake Fluid. BRAKES OVERHEATED This message is displayed when the brakes are becoming overheated. You may ...