Flash-to-Pass

This feature allows the high-beam headlamps to be used to signal the driver in front of you that you want to pass.

Pull and hold the turn signal/lane change lever toward you to use this feature. When this is done the following will occur:

- If the headlamps are off or in low-beam mode, the high-beam headlamps will turn on. They will stay on as long as the lever is held there. Release the lever to turn them off.

- If the headlamps are already in high-beam mode, they will remain on high beam.

    See also:

    Ride Control System Messages
    SERVICE STABILITRAK If your vehicle has StabiliTrak and this message displays, it means there may be a problem with the StabiliTrak system. If you see this message, try to reset the system. Stop; ...

    Heated Steering Wheel
    For vehicles with a heated steering wheel, the button for this feature is located on the steering wheel. (Heated Steering Wheel): Press to turn the heated steering wheel on or off. A light on ...

    Trailer Wiring Harness
    Heavy-Duty Trailer Wiring Harness Package The vehicle has a seven-pin universal heavy-duty trailer connector attached to the rear bumper beam next to the integrated trailer hitch. The seven-wire ...