License Plate Lamp (Wagon)

To replace one of these bulbs:

1. Open the liftgate. See Liftgate for more information.

Passenger Side Shown, Driver Side Similar
Passenger Side Shown, Driver Side Similar

2. Push the left end of the lamp assembly toward the right.

3. Turn the lamp assembly down to remove it from the liftgate.

A. Bulb Socket

A. Bulb Socket
B. Bulb
C. Lamp Assembly

4. Turn the bulb socket (A) counterclockwise to remove it from the lamp assembly (C).

5. Pull the bulb (B) straight out of the bulb socket.

6. Push the replacement bulb straight into the bulb socket and turn the bulb socket clockwise to install it into the lamp assembly.

7. Turn the lamp assembly into the liftgate engaging the clip side first.

8. Push on the lamp side opposite the clip until the lamp assembly snaps into place.

    See also:

    Storing Memory Positions
    To save into memory: 1. Adjust the driver seat, outside mirrors, and the power steering column, if equipped, to the desired driving positions. 2. Press and hold “1” until two beeps sound. 3 ...

    Safety Belts
    Refer to the following sections for important information on how to use safety belts properly: - Safety Belts - How to Wear Safety Belts Properly - Lap-Shoulder Belt - Lower Anchors and Tet ...

    Tire Pressure Monitor System
    The Tire Pressure Monitor System (TPMS) uses radio and sensor technology to check tire pressure levels. The TPMS sensors monitor the air pressure in your tires and transmit tire pressure readings ...