If the On Indicator Is Lit for a Child Restraint
If a child restraint has been installed and the on indicator is lit:
1. Turn the vehicle off.
2. Remove the child restraint from the vehicle.
3. Remove any additional items from the seat such as blankets, cushions, seat covers, seat heaters, or seat massagers.
4. Reinstall the child restraint following the directions provided by the child restraint manufacturer and refer to “Securing a Child Restraint in the Right Front Seat Position” under Securing Child Restraints (Rear Seat) or Securing Child Restraints (Front Passenger Seat).
5. If, after reinstalling the child restraint and restarting the vehicle, the on indicator is still lit, turn the vehicle off.
Then slightly recline the vehicle seatback and adjust the seat cushion, if adjustable, to make sure that the vehicle seatback is not pushing the child restraint into the seat cushion.
Also make sure the child restraint is not trapped under the vehicle head restraint.
If this happens, adjust the head restraint. See Head Restraints .
6. Restart the vehicle.
If the on indicator is still lit, secure the child restraint in a rear seat position in the vehicle, and check with your dealer.
See also:
Emergency Trunk Release Handle
Emergency Trunk Release Handle
Notice: Do not use the
emergency trunk release handle
as a tie-down or anchor point
when securing items in the trunk
as it could damage the handle.
The emerg ...
PARKING ASSIST OFF
After the vehicle has been started,
this message displays to remind the
driver that the URPA system has
been turned off. This message also
displays when there is a temporary
condition causin ...
Starting the Vehicle
1. Aim the Remote Keyless Entry
(RKE) transmitter at the vehicle.
2. Press and release .
3. Immediately after completing
Step 2, press and hold for at
least four seconds or until the
vehicl ...






