Second Row Passenger Belt Reminder Light
When the engine is started and the Trip/Fuel display is chosen, three gray safety belt symbols come on and stay on for several seconds on the top of the Driver information Center (DIC) to remind passengers to fasten their safety belts.
If the Vehicle Information is selected, a full page screen displays at start-up the three safety belt symbols.
Once the passenger safety belt is buckled, the corresponding safety belt symbol in the DIC turns green. There are no seat position sensors in the seat, nor a safety belt reminder sensor pad. If a safety belt is not initially buckled, the cluster continues to show the gray safety belt icon.
While the vehicle is moving, if a second row passenger who was previously buckled becomes unbuckled, a full screen warning displays with the corresponding safety belt indicator flashing red.
A chime may sound.
Acknowledge warning messages by pressing any of the DIC buttons.
See also:
Using Voice Commands
During a Planned Route
Cancel Route
1. Push . System responds:
“OnStar ready,” then a tone.
Say “Cancel route.” System
responds: “Would you like to
cancel route directions to your
destination?”.
2. Say “Yes.” Syst ...
SERVICE SIDE BLIND ZONE
ALERT SYSTEM
If this message appears, both SBZA
displays will remain on indicating
there is a problem with the SBZA
system. If these displays remain on
after continued driving, the system
needs service. ...
Child Restraint Systems
(A) Rear-Facing Infant Seat
A rear-facing infant seat (A) provides restraint with the seating surface
against the back of the infant.
The harness system holds the infant in place and, in a ...