Distance to Destination
This display will show the vehicle distance with estimated time of arrival to destination. The value can be cleared or reset by pressing the SET/CLR button. Move the thumbwheel up or down to increase or decrease the destination distance value. Once the distance value is set, press SET/CLR to confirm the value.
See also:
SERVICE ALL WHEEL DRIVE
This message displays if a problem
occurs with the All-Wheel Drive
(AWD) system. The vehicle will run
in 2WD. This could be caused by:
- An electronics problem
- An AWD system oil overheat
- ...
Safety Belts
Refer to the following sections for important information on how to use
safety belts properly:
- Safety Belts
- How to Wear Safety Belts Properly
- Lap-Shoulder Belt
- Lower Anchors and Tet ...
How the System Works
URPA comes on automatically when the shift lever is moved into R (Reverse). A
single tone sounds to indicate the system is working.
URPA operates only at speeds less than 8 km/h (5 mph).
An obstac ...






