Universal Remote System Operation
Using the Universal Remote System
Press and hold the appropriate Universal Remote system button for at least half of a second.
The indicator light will come on while the signal is being transmitted.
Erasing Universal Remote System Buttons
All programmed buttons should be erased when the vehicle is sold or the lease ends.
To erase all programmed buttons on the Universal Remote system device:
1. Press and hold down the two outside buttons until the indicator light begins to flash. This should take about 10 seconds.
2. Release both buttons.
Reprogramming a Single Universal Remote System Button
To reprogram any of the three Universal Remote system buttons:
1. Press and hold the desired Universal Remote system button. Do not release the button.
2. The indicator light will begin to flash after 20 seconds. Without releasing the button, proceed with Step 1 under “Programming the Universal Remote System.” If you have questions or need help programming the Universal Remote system, call 1-800-355-3515 or go to www.homelink.com. You may also call the customer assistance phone number under Customer Assistance Offices (U.S. and Canada) or Customer Assistance Offices (Mexico).
See also:
Returning the Seat to the Sitting Position
To return the seat to the sitting position from the tumbled position:
1. Pull the seat down until it latches to the floor. The seatback cannot be raised
if the seat is not latched to the floor.
...
Cargo Lamp
The cargo lamp is located in the rear compartment and is controlled by the
dome lamp. See Dome Lamps. ...
Airbag System Check
The airbag system does not need
regularly scheduled maintenance
or replacement. Make sure the
airbag readiness light is working.
See Airbag Readiness Light.
Notice: If an airbag covering is
...