Testing the Alarm
To test the alarm:
1. From inside the vehicle, lower the driver window and open the driver door.
2. Activate the system by locking the doors with the power door lock switch while the door is open, or with the RKE transmitter.
3. Get out of the vehicle, close the door and wait for the security light to go out.
4. Then reach in through the window, unlock the door with the manual door lock and open the door. This should set off the alarm.
While the alarm is set, the power door unlock switch will not work. If the alarm does not sound when it should but the headlamps flash, check to see if the horn works. The horn fuse may be blown. To replace the fuse, see Fuses and Circuit Breakers .
If the alarm does not sound or the headlamps do not flash, the vehicle should be serviced by your dealer.
See also:
Delayed Door Lock
When on, this feature will delay the locking of the doors until five seconds
after the last door is closed. You will hear three chimes to signal delayed
locking is in use.
Pressing either the pow ...
Engine Oil Additives/Engine Oil Flushes
Do not add anything to the oil. The recommended oils with the dexos specification
and displaying the dexos certification mark are all that is needed for good performance
and engine protection.
En ...
Armrest Storage
For vehicles with a rear seat armrest, pull the rear seat armrest forward to
access cupholders with removable liners. For vehicles with a rear storage area,
pull the lever to access. ...






