Hitch Cover (with Dual Exhaust)

To remove the hitch cover:

1. Turn the fasteners on the lower tabs 90 degrees counterclockwise.

1. Turn the fasteners on the lower tabs 90 degrees counterclockwise.
2. Pull the lower edge of the cover out slightly.
3. Lift the cover up off the upper bracket.

To reinstall the hitch cover:

1. Insert the tabs on the hitch cover into the slots in the upper bracket.
2. Move the bottom of the cover forward.
3. Turn the fasteners on the lower tabs 90 degrees clockwise to lock the cover in place.

    See also:

    Lower Anchor and Top Tether Anchor Locations
    Rear Seat (Top Tether Anchor): Seating positions with top tether anchors. (Lower Anchor): Seating positions with two lower anchors. To assist you in locating the lower anchors, each s ...

    What to Use
    To determine what kind of fluid to use, see Recommended Fluids and Lubricants  . Always use the proper fluid. Notice: Use of the incorrect fluid may damage the vehicle and the damages may not ...

    Vehicle Overview
    Cadillac takes another step into rear-wheel-drive territory with its new STS sedan, which replaces the front-wheel-drive Seville. Built on a Sigma-based architecture, like the automaker's smaller ...