Adding Washer Fluid
The vehicle has a low washer fluid message on the DIC that comes on when the washer fluid is low. The message is displayed for 15 seconds at the start of each ignition cycle. When the WASHER FLUID LOW ADD FLUID message displays, washer fluid will need to be added to the windshield washer fluid reservoir.

Open the cap with the washer symbol on it. Add washer fluid until the tank is full. See Engine Compartment Overview for reservoir location.
Notice
- When using concentrated washer fluid, follow the manufacturer's instructions for adding water.
- Do not mix water with ready-to-use washer fluid. Water can cause the solution to freeze and damage the washer fluid tank and other parts of the washer system.
- Fill the washer fluid tank only three-quarters full when it is very cold. This allows for fluid expansion if freezing occurs, which could damage the tank if it is completely full.
- Do not use engine coolant (antifreeze) in the windshield washer. It can damage the windshield washer system and paint.
See also:
Cargo Tie-Downs
For vehicles equipped with cargo tie—downs, the four tie-downs are located
in the rear compartment of the vehicle. Use the tie-downs to secure small
loads. ...
Head Restraints
WARNING
With head restraints that are not installed and adjusted properly, there is a
greater chance that occupants will suffer a neck/ spinal injury in a crash. Do not
drive until the head ...
Heated Rear Seats
The buttons are on the Rear Sear Audio (RSA) panel on the rear of the center
console.
Press or
to heat the left outboard or right
outboard seat cushion and to cycle through the temperature s ...






