How to Check Lubricant

To get an accurate reading, the vehicle should be on a level surface.

A. Drain Plug

A. Drain Plug
B. Fill Plug

If the level is below the bottom of the fill plug hole, located on the transfer case, some lubricant will need to be added. Add enough lubricant to raise the level to the bottom of the fill plug hole. Use care not to overtighten the plug.

    See also:

    Storing the Fe
    1. Lift the cargo management system cover. 2. Release the cover from the prop rod as described in the previous steps. 3. Insert the top of the fence into the lower two clips (A). 4. Turn the ...

    Unable to Connect to OnStar Message
    If there is limited cellular coverage or the cellular network has reached maximum capacity, this message may come on. Push to try the call again or try again after driving a few miles into ...

    Using the Tire Sealant and Compressor Kit without Sealant to Inflate a Tire (Not Punctured)
    To use the air compressor to inflate a tire with air only and not sealant: If a tire goes flat, avoid further tire and wheel damage by driving slowly to a level place. Turn on the hazard warning ...