Storing the Tire Sealant and Compressor Kit
The tire sealant and compressor kit is located under the storage tray on the driver side trim panel (over the rear wheelhouse).
To access the tire sealant and compressor kit:
1. Remove the tray by pulling up on the finger depression to access the tire sealant and compressor kit.
2. Locate the tire sealant and compressor kit.
3. Remove the sealant and compressor kit by pulling the velcro strip up and back.
4. Remove the sealant and compressor kit from its plastic tray assembly.
To store the tire sealant and compressor kit, reverse the steps.
See also:
SBZA Detection Zones
The SBZA sensor covers a zone
of approximately one lane over
from both sides of the vehicle,
or 3.5m(11 ft). This zone starts at
each side mirror and goes back
approximately 5.0 m(16 ft).
T ...
When the System Does Not Seem to Work Properly
The following messages may be displayed on the DIC:
SERVICE PARKING ASSIST: If this message occurs, take the vehicle to your dealer
for repair.
PARKING ASSIST OFF: This message occurs if the drive ...
StabiliTrak® OFF Light
This light should come on briefly as the vehicle is started. If it does not
come on, have the vehicle serviced by your dealer.
This light comes on when the StabiliTrak system is turned off by ...