Conditions in Which Remote Start Will Not Work
The remote vehicle start feature will not operate if any of the following occur:
- The ignition is in any position other than LOCK/OFF.
- A keyless access transmitter is inside the vehicle.
- The vehicle's hood is not closed.
- The hazard warning flashers are on.
- There is an emission control system malfunction.
- The engine coolant temperature is too high.
- The oil pressure is low.
- Two remote vehicle starts have already been used.
The maximum number of remote starts or remote start attempts between ignition cycles with the key is two.
See also:
How to Check Power Steering Fluid
Notice: Extremely small amounts of contamination can cause steering system damage
and cause it to not work properly. Do not allow contaminants to contact the fluid
side of the reservoir cap/ dipst ...
Backing Up
Hold the bottom of the steering wheel with one hand. To move the trailer to
the left, move that hand to the left. To move the trailer to the right, move
your hand to the right. Always back up slowly ...
Setting the Power Liftgate 3/4 Mode
To change the liftgate stop position.
1. Turn the liftgate switch to either the MAX, or the 3/4 mode position and
power open the liftgate.
2. Stop the liftgate movement at the desired height by p ...






