Remote Vehicle Start

With this feature the engine can be started from outside of the vehicle.

Starting the Vehicle

1. Press and release src=on the RKE transmitter." width=15 height=20 id="_x0000_i1061" src="images/books/1183/1/index.39.gif" border=0>on the RKE transmitter.
2. Within two seconds, press and hold src=until the turn signal lamps flash, or for" width=22 height=22 id="_x0000_i1062" src="images/books/1183/1/index.40.gif" border=0>until the turn signal lamps flash, or for at least two seconds if the vehicle is not in view.

When the vehicle starts, the parking lamps will turn on and remain on as long as the engine is running.

The doors will be locked and the climate control system may come on.

The engine will continue to run for 10 minutes. Repeat the steps for a 10-minute time extension. Remote start can be extended only once.

Canceling a Remote Start

To cancel a remote start, do any of the following:

- Press and hold src=until the parking lamps turn off." width=22 height=22 id="_x0000_i1063" src="images/books/1183/1/index.40.gif" border=0>until the parking lamps turn off.
- Turn on the hazard warning flashers.
- Turn the vehicle on and then off.

    See also:

    Automatic Fold and Tumble Feature
    The transmission must be in P (Park) for this feature to work. WARNING Automatically folding and tumbling the seat when someone is sitting in the seat, could cause injury to the person sittin ...

    Automatic EPB Release
    The EPB will automatically release if the vehicle is running, placed into gear, and an attempt is made to drive away. Avoid rapid acceleration when the EPB is applied, to preserve park brake ...

    SBZA Detection Zones
    The SBZA sensor covers a zone of approximately one lane over from both sides of the vehicle, or 3.5m(11 ft). This zone starts at each side mirror and goes back approximately 5.0 m(16 ft). T ...