Conditions in Which Remote Start Will Not Work
The remote start will not operate if any of the following occur:
- The ignition is in any mode other than OFF.
- The transmitter is in the vehicle.
- The hood is not closed.
- The hazard warning flashers are on.
- There is an emission control system malfunction.
- The engine coolant temperature is too high.
- The oil pressure is low.
- Two remote vehicle starts have already been used.
- The vehicle is not in P (Park).
See also:
Using the Tire Sealant and Compressor Kit without Sealant to Inflate a Tire
(Not Punctured)
To use the air compressor to inflate a tire with air only and not sealant:
If a tire goes flat, avoid further tire and wheel damage by driving slowly to
a level place. Turn on the hazard warning ...
Certification Label
Label Example
A vehicle-specific Certification
label is attached to either the
driver door edge or the lower
center pillar on the driver side of
the vehicle. The label tells the
gross wei ...
Exterior
Cadillac says stealth fighters inspired the XLR, which serves as "a
contemporary expression of Cadillac's heritage of landmark design and advanced
technology." Linear lines display hints ...