Vehicles Without a Navigation System

When the vehicle is on and the driver shifts into R (Reverse), the video image automatically appears on the inside rearview mirror. Once the driver shifts out of R (Reverse), the video image automatically disappears from the inside rearview mirror.

Turning the Rear Vision Camera System Off or On

To turn off the RVC system, press and hold id=, located on the inside" width=24 height=17 id="_x0000_i1668" src="images/books/1183/7/index.71.gif" border=0>, located on the inside rearview mirror, until the left indicator light turns off.

The RVC display is now disabled.

To turn the RVC system on again, press and hold id=  until the left" width=24 height=17 id="_x0000_i1669" src="images/books/1183/7/index.72.gif" border=0>  until the left indicator light illuminates. The RVC system display is now enabled and the display will appear in the mirror normally.

    See also:

    Ultrasonic Parking Assist
    If available, the Ultrasonic Rear Parking Assist (URPA) system uses sensors on the rear bumper to assist with parking and avoiding objects while in R (Reverse). It operates at speeds less than 8 k ...

    OnStar Additional Information
    Transferring Service Push to request account transfer eligibility information. The Advisor can assist in canceling or removing account information. If OnStar receives information that vehicle ow ...

    SBZA Detection Zones
    The SBZA sensor covers a zone of approximately one lane over from both sides of the vehicle, 3.5m (11 ft). This zone starts at each side mirror and goes back approximately 5.0m(16 ft). The heigh ...