Clock
The analog clock is not connected with any other vehicle system and runs by itself.
To adjust the clock, do the following:
1. Locate the adjustment button, near the lower left corner of the clock.
2. Push and hold the adjustment button to advance the clock hands. Holding the button down will cause the clock to advance faster. Release the button before you get to the desired time.
3. Push and release the button to increase the time by one minute increments until the desired time is reached.
See also:
Parking on Hills
WARNING!
Parking the vehicle on a hill with
the trailer attached can be
dangerous. If something goes
wrong, the rig could start to move.
People can be injured, and both
the vehicle and the t ...
Three-Way Calling
Three-Way Calling must be
supported on the cell phone and
enabled by the wireless service
carrier to work.
1. While on a call press .
2. Say “Three-way call.”
3. Use the dial or call command ...
Compass Calibration Procedure
1. Before calibrating the compass,
check that the compass is set
to the correct variance zone.
See “Compass Variance (Zone)
Procedure” earlier in this
section.
Do not operate any switches
...






