Universal Remote System Operation
Press and hold the appropriate button for at least half of a second. The indicator light will come on while the signal is being transmitted.
Reprogramming Universal Home Remote Buttons
Any of the three buttons can be reprogrammed by repeating the instructions.
Erasing Universal Home Remote Buttons
The programmed buttons should be erased when the vehicle is sold or the lease ends.
To erase either Rolling Code or Fixed Code settings on the Universal Home Remote device:
1. Press and hold the two outside buttons at the same time for approximately 20 seconds, until the indicator lights, located directly above the buttons, begin to blink rapidly.
2. Once the indicator lights begin to blink, release both buttons. The codes from all buttons will be erased.
For help or information on the Universal Home Remote System, call the customer assistance phone number under Customer Assistance Offices (U.S. and Canada) or Customer Assistance Offices (Mexico) .
See also:
If No Steam Is Coming from the Engine Compartment
If an engine overheat warning is displayed but no steam can be seen or
heard, the problem may not be too serious. Sometimes the engine can get a
little too hot when the vehicle:
- Climbs a long h ...
Navigation Symbols
The following symbols are the most common symbols that appear on a map screen.
The vehicle is shown as this symbol. It indicates the current position and the
direction the vehicle is traveling on ...
OnStar®
If the vehicle is equipped with
an active OnStar system, that
system may also record data in
crash or near crash-like situations.
The OnStar Terms and Conditions
provides information on data ...