Storing Memory Positions

To save into memory:

1. Adjust the driver seat, outside mirrors, and the power steering column, if equipped, to the desired driving positions.

2. Press and hold “1” until two beeps sound.

3. Repeat for a second driver using “2.” To recall memory positions, press and release “1” or “2.” The vehicle must be in P (Park) for an automatic transmission, or the parking brake must be applied for a manual transmission. A single beep will sound when the button is pressed.

The seat, outside mirrors, and/or power steering column will move to the position previously stored for the identified driver.

If entry/exit recall is programmed on in the vehicle personalization menu, automatic entry recall occurs when the ignition is turned on.

See Memory Seats and Vehicle Personalization.

    See also:

    Retained Accessory Power (RAP)
    The following vehicle accessories can be used for up to 10 minutes after the engine is turned off: Audio System Power Windows OnStar System (if equipped) Sunroof (if equipped) These fea ...

    Power Outlets
    The accessory power outlets can be used to plug in electrical equipment, such as a cell phone or MP3 player. The vehicle has three accessory power outlets located: Inside the floor console stor ...

    License Plate Lamp
    1. Remove the two screws holding each of the license plate lamps to the molding that is part of the liftgate. 2. Twist and pull the license plate lamp assembly forward through the molding openi ...