Manual Transmission
The shift lever should be in neutral position and the parking brake engaged. Hold the clutch pedal down to the floor and start the engine. The vehicle will not start if the clutch pedal is not all the way down.
See also:
Compass Calibration Procedure
1. Before calibrating the compass,
check that the compass is set
to the correct variance zone.
See “Compass Variance (Zone)
Procedure” earlier in this
section.
Do not operate any switches
...
Clock
The analog clock is not connected with any other vehicle system and runs by itself.
To adjust the clock, do the following:
1. Locate the adjustment button, near the lower left corner of the clock.
...
How the System Works
URPA comes on automatically when the shift lever is moved into R (Reverse). A
single tone sounds to indicate the system is working.
URPA operates only at speeds less than 8 km/h (5 mph).
An obstac ...