Starting the Engine

Place the transmission in the proper gear.

If the vehicle has the keyless access system, the keyless access transmitter must be authenticated in order for the ignition control knob to turn. The transmitter can be authenticated either by putting your foot on the brake pedal or by pushing the ignition control knob in.

See also:

Leaving After Parking on a Hill
1. Apply and hold the brake pedal while you: - Start the engine. - Shift into a gear. - Release the parking brake. 2. Let up on the brake pedal. 3. Drive slowly until the trailer is clear of ...

Cupholders
There are cupholders in the front of the center console. Push the cover to open. There are also cupholders in the rear center armrest. Pull the armrest down to use. ...

Adding Washer Fluid
The vehicle has a low washer fluid message on the DIC that comes on when the washer fluid is low. The message is displayed for 15 seconds at the start of each ignition cycle. When the WASHER FLUID ...