Using Voice Commands During a Planned Route
Cancel Route
1. Push . System responds:
“OnStar ready,” then a tone.
Say “Cancel route.” System responds: “Would you like to cancel route directions to your destination?”.
2. Say “Yes.” System responds:
“OK, route canceled.”.
3. Say “Goodbye.” Exits voice commands.
Route Preview
1. Push . System responds:
“OnStar ready,” then a tone.
2. Say “Route Preview.” System responds with the next three maneuvers.
3. Say “Goodbye.” Exits voice commands.
Repeat
1. Push . System responds:
“OnStar ready,” then a tone.
2. Say “Repeat.” System responds with the last direction given, then responds with “OnStar ready,” then a tone.
3. Say “Goodbye.” Exits voice commands.
Get My Destination
1. Push . System responds:
“OnStar ready,” then a tone.
2. Say “Get my destination.”.
System responds with miles to the destination, then responds with “OnStar ready,” then a tone.
3. Say “Goodbye.” Exits voice commands.
See also:
Automatic Operation
AUTO (Automatic): When automatic operation is active the system will control
the inside temperature, the air delivery, and the fan speed.
Use the steps below to place the entire system in automatic ...
Cargo Management System
To open the cargo management system, press the rear of the handle to unlatch
it and then lift the handle up.
A prop rod locks to hold the cover up when opened.
Four hooks are located on ...
Testing the Alarm
To test the alarm:
1. From inside the vehicle, lower the driver window and open the driver door.
2. Activate the system by locking the doors with the power door lock switch while
the door is open, ...