Obstacle Detection Features
If the liftgate encounters an obstacle during a power open or close cycle, a warning chime will sound and the liftgate will automatically reverse direction to the full closed or open position.
After removing the obstruction, the power liftgate operation can be used again. If the liftgate encounters multiple obstacles on the same power cycle, the power function will deactivate. After removing the obstructions, the liftgate will resume normal power operation.
The vehicle has pinch sensors located on the side edges of the liftgate. If an object is caught between the liftgate and the body and presses against this sensor, the liftgate will reverse direction and open fully. The liftgate will remain open until it is activated again or closed manually.
See also:
Using Voice Commands During a Planned Route
Cancel Route
1. Push . System responds: “OnStar
ready,” then a tone. Say “Cancel route.” System responds: “Would you like to cancel
route directions to your destination?”
2. Say “Yes.” System re ...
Removing and Replacing the
Floor Mats
1. Pull up on the rear of the floor
mat to unlock the retainer and
remove.
2. Reinstall by lining up the floor
mat retainer opening over the
carpet retainer and snap into
position.
3. Ma ...
Tow/Haul Mode Light
For vehicles with the Tow/Haul Mode feature, this light comes on when the Tow/Haul
Mode has been activated.
For more information, see Tow/Haul Mode . ...