Headlamp Washer
For vehicles with headlamp washers, they are located to the side of the headlamps.
The headlamps must be on in order to use the headlamp washers.
If the headlamps are not on, only the windshield will be washed.
Pull the wiper lever toward you and hold briefly to activate.
The headlamp washers will spray once, pause, and spray again.
The headlamp washer will spray again after five windshield wash cycles.
See Washer Fluid for information on filling the windshield washer fluid.
See also:
Lumbar Adjustment
To adjust the lumbar support:
Press and hold the front or rear of the control to increase or decrease
lumbar support.
Press and hold the top or bottom of the control to raise or lower the
...
Jump Starting
For more information about the vehicle battery, see Battery.
If the vehicle battery has run down, you may want to use another vehicle and
some jumper cables to start your vehicle. Be sure to use t ...
Turning the System On and Off
The system can be disabled through
the Driver Information Center (DIC).
See “Parking Assist” under Driver
Information Center (DIC) for more information.
URPA defaults to the on setting
each ti ...






