Adjusting the Speakers (Balance/Fade)
BAL/FADE (Balance/Fade):
To adjust balance or fade:
1. Press the TUNE/TONE knob until the speaker control tabs display.
2. Continue pressing the TUNE/ TONE knob, or press the softkey under the desired tab to highlight the desired tone setting.
3. To increase the highlighted setting, do one of the following:
- Turn the TUNE/TONE knob clockwise.
- Turn the MENU/SELECT knob clockwise.
- Press the 
button.
- Press the 
button.
4. To decrease the highlighted setting, do one of the following:
- Turn the TUNE/TONE knob counterclockwise.
- Turn the MENU/SELECT knob counterclockwise.
- Press the 
button.
- Press the 
button.
To quickly adjust balance or fade to the middle position, press the softkey under the BAL or FADE tab for more than two seconds.
To quickly adjust all speaker and tone controls to the middle position, press the TUNE/TONE knob for more than two seconds.
See also:
Setting Cruise Control
If the cruise button is on when not in use, it could get bumped and go into cruise
when not desired. Keep the cruise control switch off when cruise is not being used.
The cruise control light on th ...
Battery
Refer to the replacement number shown on the original battery label when a
new battery is needed.
See Engine Compartment Overview for battery location.
WARNING
Battery posts, terminals, and r ...
SBZA Detection Zones
The SBZA sensor covers a zone of approximately one lane over from both sides
of the vehicle, 3.5m (11 ft). This zone starts at each side mirror and goes back
approximately 5.0m(16 ft). The heigh ...