Turning the System On and Off
The UFRPA system can be turned on and off by pressing the park assist button located next to the shift lever.
The LED next to the park assist button lights up when the system is on and turns off when it has been disabled.
When the system is off, PARK ASSIST OFF displays on the Driver Information Center (DIC).
The message disappears after a short period of time.
UFRPA defaults to the on setting each time the vehicle is started.
See also:
Headlamp High/Low-Beam Changer
Push the turn signal/lane change
lever away from you to turn the high
beams on. Pull the lever toward you
and then release it to return to low
beams.
If the vehicle is turned off while the
...
Interior Care
To prevent dirt particle abrasions, regularly clean the vehicle's interior.
Immediately remove any soils. Note that newspapers or dark garments that can
transfer color to home furnishings can also ...
Storing the Tire Sealant and Compressor Kit
The tire sealant and compressor kit is located under the storage tray on the
driver side trim panel (over the rear wheelhouse).
To access the tire sealant and compressor kit:
1. Remove the tray ...