Driver Side
The removal of the underhood electrical center is required for the replacement of one of these bulbs:
1. Open the hood. See Hood.
WARNING
Liquids from environment or spillage and/or tools placed on top of or used in
the underhood electrical center while the cover is removed can pose a risk of
electrical shock/burn to anyone in the vicinity. These conditions can also
cause damage to electrical components on the vehicle. Keep liquids and tools
away from the underhood electrical center when the cover is removed.
2. Unlatch three clips and lift up the underhood electrical center cover to remove.
See also:
Airbag System
The vehicle has the following airbags:
- A frontal airbag for the driver.
- A frontal airbag for the front outboard passenger.
- A seat-mounted side impact airbag for the driver.
- A seat-mounte ...
Fog Lamps
To replace a front fog lamp bulb:
1. Pull out the push-pins located on
the underside of the protection
shield to remove the shield.
2. Reach up behind the front
bumper area from under the
...
SERVICE ALL WHEEL DRIVE
This message displays if a problem
occurs with the All-Wheel Drive
(AWD) system. The vehicle will run
in 2WD. This could be caused by:
- An electronics problem
- An AWD system oil overheat
- ...