CD/DVD Messages
If Disc Read Error appears on the display and/or the CD/DVD comes out, it could be for one of the following reasons:
- If a CD was inserted with an invalid or unknown format.
- If a DVD is not from a correct region.
- It is very hot. When the temperature returns to normal, the CD should play.
- You are driving on a very rough road. When the road becomes smoother, the CD/DVD should play.
- The CD/DVD is dirty, scratched, wet, or upside down.
- The air is very humid. If so, wait about an hour and try again.
- There may have been a problem while burning the CD/DVD.
- The label may be caught in the CD/DVD player.
If the CD/DVD is not playing correctly, for any other reason, try a known good CD/DVD.
If any error occurs repeatedly or if an error cannot be corrected, contact your dealer.
See also:
Instrument Panel Fuse Block
The instrument panel fuse block is located in the center console between the
driver and passenger seats. To access the fuses, open the fuse panel door from
the passenger side by pulling it out.
...
Leaving After Parking on a Hill
1. Apply and hold the brake pedal
while you:
1.1. Start the engine.
1.2. Shift into a gear.
1.3. Release the parking brake.
2. Let up on the brake pedal.
3. Drive slowly until the trailer is
...
SERVICE TIRE MONITOR
SYSTEM
This message displays if a part on
the Tire Pressure Monitor System
(TPMS) is not working properly.
The tire pressure light also flashes
and then remains on during the
same ignition cycle. Se ...






