Starter Switch Check
WARNING
When you are doing this inspection, the vehicle could move suddenly. If the vehicle moves, you or others could be injured.
1. Before starting this check, be sure there is enough room around the vehicle.
2. Firmly apply both the parking brake and the regular brake. See Parking Brake .
Do not use the accelerator pedal, and be ready to turn off the engine immediately if it starts.
3. Try to start the engine in each gear. The vehicle should start only in P (Park) or N (Neutral). If the vehicle starts in any other position, contact your dealer for service.
See also:
Ignition Positions
(Keyless Access)
The ignition control knob can be
turned to four different positions.
To shift out of P (Park), the
ignition must be in ON/RUN or
ACC/ACCESSORY and the regular
brake pedal must be applied.
...
Bulb Replacement
For the proper type of replacement bulbs, see Replacement Bulbs.
For any bulb changing procedure not listed in this section, contact your
dealer. ...
Compass
Your vehicle may have a compass in the Driver Information Center (DIC).
Compass Zone
The zone is set to zone eight upon leaving the factory. Your dealer will set
the correct zone for your location ...