Park Brake and P (Park) Mechanism Check

WARNING WARNING

When you are doing this check, the vehicle could begin to move. You or others could be injured and property could be damaged. Make sure there is room in front of the vehicle in case it begins to roll. Be ready to apply the regular brake at once should the vehicle begin to move.

Park on a fairly steep hill, with the vehicle facing downhill. Keeping your foot on the regular brake, set the parking brake.

  • To check the parking brake's holding ability: With the engine running and the transmission in N (Neutral), slowly remove foot pressure from the regular brake pedal. Do this until the vehicle is held by the parking brake only.
  • To check the P (Park) mechanism's holding ability: With the engine running, shift to P (Park). Then release the parking brake followed by the regular brake.

Contact your dealer if service is required.

    See also:

    High Intensity Discharge (HID) Lighting
    WARNING The low beam high intensity discharge lighting system operates at a very high voltage. If you try to service any of the system components, you could be seriously injured. Have your dealer ...

    2013 Cadillac ATS Review
    Topping out third gear I’ve got just enough time to think about grabbing fourth when the first braking marker is past my front tire and I’m pushing hard on the four piston Brembos. The lightest ca ...

    Sensors
    The solar sensor located on the instrument panel, near the windshield, monitors the solar heat. The interior temperature sensor, located on the instrument panel to the right of the steeri ...