License Plate Lamp
1. Remove the two screws holding each of the license plate lamps to the molding that is part of the liftgate.
2. Twist and pull the license plate lamp assembly forward through the molding opening.
3. Remove the bulb socket from the lamp assembly by turning it counterclockwise.
4. Pull the bulb straight out of the socket and install the new bulb.
5. Reverse Steps 1 through 3 to reinstall the license plate lamp.
See also:
UHP Controls
Use the buttons located on the infotainment system and the steering wheel to
operate the UHP system.
Steering Wheel Controls
Steering wheel controls can be used to:
- Answer incoming calls
...
Turn Signal Lamps
To replace one of these bulbs:
1. Open the liftgate. See Liftgate .
A. Push Pin
B. Taillamp Cover
2. Pull on push pin (A) to release the taillamp cover (B).
3. Remove the taillamp cover ...
Clock
The analog clock is not connected with any other vehicle system and runs by itself.
To adjust the clock, do the following:
1. Locate the adjustment button, near the lower left corner of the clock.
...